• Intended for rounded corner application points on thermoplastic parts such as bumpers and clips
• A curved application staple, it can help with a rounded corner
• This is an alternative to the M-Clip which would leave an exposed staple
• Also effective in curved areas around screw and plastic rivet holes
• This small design element will cut cycle time and save technicians extra steps
• The leads are notched like someone took an axe to a tree, allowing them to be snapped off with a hand, instead of having to go back with snips
• The time savings does not stop there: if sunken deep enough the leads will break below the surface of the plastic eliminating the need to go back over with a grinder later
• Over time these simple improvements make the difference in profitability and not going over the allocated time
|